Drop mic gain out of saturation and soften the noise gate
The hardware log showed the live mic slots sitting at ~0.6 RMS in ambient noise. At 37.5 dB the ES7210 was clipping, so the noise floor slowly climbed to the saturated level and the gate never fired again: the blip appeared once and then vanished forever. Use 18 dB analog gain so ambient levels have headroom, lower the gate to 1.5x the floor so real sounds stand out, and widen the loudness window to -50..-6 dBFS. The debug line now also prints the floor-relative signal levels.
This commit is contained in:
@@ -22,7 +22,7 @@
|
||||
#define MIC_I2S_PORT I2S_NUM_1
|
||||
#define MIC_BLOCK_FRAMES 256 // 16 ms at 16 kHz
|
||||
#define MIC_SLOTS 4 // 4-slot TDM
|
||||
#define MIC_GAIN GAIN_37_5DB
|
||||
#define MIC_GAIN GAIN_18DB
|
||||
|
||||
// Set to 1 to print detected levels while tuning the microphones on hardware.
|
||||
#ifndef SOUND_DETECTOR_DEBUG
|
||||
@@ -43,8 +43,8 @@ static constexpr float FLOOR_MARGIN = 1.25f;
|
||||
static constexpr float ABS_GATE = 0.0008f;
|
||||
static constexpr float BALANCE_DEADBAND = 0.02f;
|
||||
static constexpr float BALANCE_GAIN = 1.8f; // widen the usable stereo range
|
||||
static constexpr float LOUD_MIN_DB = -60.0f;
|
||||
static constexpr float LOUD_MAX_DB = -20.0f;
|
||||
static constexpr float LOUD_MIN_DB = -50.0f;
|
||||
static constexpr float LOUD_MAX_DB = -6.0f;
|
||||
static constexpr uint32_t HOLD_MS = 260;
|
||||
|
||||
// Slot discovery: the codec emits four TDM slots but only two microphones are
|
||||
@@ -295,8 +295,8 @@ void SoundDetector::processBlock(const int16_t *frames, size_t frameCount)
|
||||
if (sigR < 0.0f) sigR = 0.0f;
|
||||
|
||||
// Adaptive gate: a sound must stand clearly above its channel's floor.
|
||||
float gateL = fmaxf(floorL_ * 2.0f, ABS_GATE);
|
||||
float gateR = fmaxf(floorR_ * 2.0f, ABS_GATE);
|
||||
float gateL = fmaxf(floorL_ * 1.5f, ABS_GATE);
|
||||
float gateR = fmaxf(floorR_ * 1.5f, ABS_GATE);
|
||||
bool present = (sigL > gateL) || (sigR > gateR);
|
||||
|
||||
uint32_t now = millis();
|
||||
@@ -332,9 +332,9 @@ void SoundDetector::processBlock(const int16_t *frames, size_t frameCount)
|
||||
if ((uint32_t)(millis() - lastPrintMs) > 1000) {
|
||||
lastPrintMs = millis();
|
||||
Serial.printf("mic rms %.4f %.4f %.4f %.4f | pair L%d R%d | "
|
||||
"bal %+.2f loud %.2f%s\n",
|
||||
"sig %.3f %.3f | bal %+.2f loud %.2f%s\n",
|
||||
rms[0], rms[1], rms[2], rms[3],
|
||||
leftSlot_, rightSlot_, balance, loudness,
|
||||
leftSlot_, rightSlot_, sigL, sigR, balance, loudness,
|
||||
active ? "" : " (quiet)");
|
||||
}
|
||||
#endif
|
||||
|
||||
Reference in New Issue
Block a user