Fix trackball click: I2S MCLK was claiming GPIO0; emulator pin-ownership parity

Root cause (on device): sound_engine zero-initialized i2s_pin_config_t,
leaving mck_io_num == 0. i2s_set_pin() then claimed GPIO0 — an
MCLK-capable pin on the S3 and the trackball centre / BOOT line — as
its MCLK output. Verified on device with a diagnostic build: pin0 read
LOW at idle, exactly one latched FALLING edge, clicks never registered.

- sound_engine: set pins.mck_io_num = I2S_PIN_NO_CHANGE explicitly.
- NetDeck: register the trackball click on release with contact-bounce
  collapse (the proven CrtTerminal pattern); pollTouch re-arms when
  isPressed() stays true but getPoint() reports no points (stuck GT911
  IRQ on some units).
- Emulator parity (so this class of bug dies before flashing):
  GPIO-matrix pin-ownership model in the shim — i2s_set_pin() claims
  its pins, claimed pins are dead inputs (digitalRead LOW, no edges,
  loud WARNING on claim/ISR collisions); host pin writes go through
  emu::setPin/togglePin with an edge-accurate ISR latch (a full
  press+release pulse between dispatches no longer gets swallowed);
  E2E inits SDL_INIT_AUDIO so the I2S path actually runs there.
  Regression coverage: e2e/trackball_click (fails on the old engine),
  unit/shim_claimed_pin_is_dead_input,
  unit/shim_edge_survives_same_dispatch_pulse.
- Makefile: firmware step follows the sketch move (root platformio.ini,
  src_dir = src/netdeck).
- HW.md: new notes file for emulator-vs-hardware quirks and the
  on-device debugging recipe.

On-device verified: clicks register in both views (beacon drops, node
routing). Fast layer 23 unit + 7 integration green. Note: e2e
boot_and_controls + network_journey failures are pre-existing at HEAD
(reproduced on a clean stash before this change).
This commit is contained in:
Dejvino
2026-11-15 10:24:30 +01:00
parent 4645c7a1c6
commit 1dcc87d8d4
12 changed files with 368 additions and 30 deletions
+2 -2
View File
@@ -24,8 +24,8 @@ endif
netdeck:
@echo "=== [1/2] NetDeck firmware (ESP32-S3, pio) ==="
$(PIO) run -d examples/NetDeck
@echo "=== [2/2] NetDeck emulator (SDL2) ==="
$(PIO) run -e T-Deck
@echo "=== [2/2] NetDeck emulator (SDL3) ==="
$(MAKE) --no-print-directory -C emulator APP=NetDeck
@echo "=== both NetDeck targets built OK ==="