/** * @file sound_detector.cpp * @brief ES7210 dual-microphone capture + stereo balance/loudness detector. * * The T-Deck Plus has two populated MEMS microphones on the ES7210. The codec * outputs all four ADC channels as a 4-slot TDM stream on SDOUT1: * slot 0 = MIC1 (left), slot 2 = MIC3 (right) * We only need slots 0 and 2; slot 1/3 are ignored. * * The detector runs in its own FreeRTOS task so the radar loop never blocks on * I2S. It publishes smoothed, noise-floor-relative levels that the sketch turns * into a blip angle (balance) and distance (loudness). */ #include "sound_detector.h" #include "utilities.h" #include "es7210.h" #include #include #define MIC_I2S_PORT I2S_NUM_1 #define MIC_BLOCK_FRAMES 256 // 16 ms at 16 kHz #define MIC_CHANNELS 4 // 4-slot TDM #define MIC_SLOT_LEFT 0 // MIC1 #define MIC_SLOT_RIGHT 2 // MIC3 #define MIC_GAIN GAIN_30DB // Set to 1 to print detected levels while tuning the microphones on hardware. #ifndef SOUND_DETECTOR_DEBUG #define SOUND_DETECTOR_DEBUG 0 #endif // Envelope / detector tuning (per 16 ms block). static constexpr float ENV_ATTACK = 0.55f; static constexpr float ENV_RELEASE = 0.18f; static constexpr float FLOOR_FALL = 0.12f; // fast follow when quieter static constexpr float FLOOR_RISE = 0.0008f; // very slow drift upward static constexpr float FLOOR_MARGIN = 1.25f; static constexpr float ABS_GATE = 0.0008f; static constexpr float BALANCE_DEADBAND = 0.06f; static constexpr float LOUD_MIN_DB = -48.0f; static constexpr float LOUD_MAX_DB = -6.0f; static constexpr uint32_t HOLD_MS = 260; // ES7210 SDP interface 2 / high-pass registers. The LilyGO driver leaves the // codec in 2-channel I2S mode and the HPF disabled; enable both here. static const uint8_t ES7210_SDP_INTERFACE2 = 0x12; static const uint8_t ES7210_ADC34_HPF2 = 0x20; static const uint8_t ES7210_ADC34_HPF1 = 0x21; static const uint8_t ES7210_ADC12_HPF1 = 0x22; static const uint8_t ES7210_ADC12_HPF2 = 0x23; static bool es7210WriteReg(uint8_t reg, uint8_t value) { Wire.beginTransmission(ES7210_ADDR); Wire.write(reg); Wire.write(value); return Wire.endTransmission() == 0; } bool SoundDetector::begin(uint32_t sampleRate) { if (running_) return true; sampleRate_ = sampleRate; audio_hal_codec_config_t cfg = {}; cfg.adc_input = AUDIO_HAL_ADC_INPUT_ALL; cfg.codec_mode = AUDIO_HAL_CODEC_MODE_ENCODE; cfg.i2s_iface.mode = AUDIO_HAL_MODE_SLAVE; cfg.i2s_iface.fmt = AUDIO_HAL_I2S_NORMAL; cfg.i2s_iface.samples = AUDIO_HAL_16K_SAMPLES; cfg.i2s_iface.bits = AUDIO_HAL_BIT_LENGTH_16BITS; esp_err_t err = es7210_adc_init(&Wire, &cfg); err |= es7210_adc_config_i2s(cfg.codec_mode, &cfg.i2s_iface); // Put all four ADCs on SDOUT1 as TDM slots. Without 0x02 on this register // only MIC1/MIC2 reach SDOUT1 and the right microphone is missing. if (!es7210WriteReg(ES7210_SDP_INTERFACE2, 0x02)) { Serial.println("ES7210 TDM config failed"); return false; } // High-pass the ADC outputs so the detector sees audio, not DC offset. es7210WriteReg(ES7210_ADC12_HPF2, 0x2a); es7210WriteReg(ES7210_ADC12_HPF1, 0x0a); es7210WriteReg(ES7210_ADC34_HPF2, 0x0a); es7210WriteReg(ES7210_ADC34_HPF1, 0x2a); // Use the same analog gain on both populated mics so the amplitude // difference between them is meaningful. err |= es7210_adc_set_gain(ES7210_INPUT_MIC1, MIC_GAIN); err |= es7210_adc_set_gain(ES7210_INPUT_MIC3, MIC_GAIN); err |= es7210_adc_ctrl_state(cfg.codec_mode, AUDIO_HAL_CTRL_START); if (err != ESP_OK) { Serial.println("ES7210 init failed"); return false; } i2s_config_t i2s = {}; i2s.mode = (i2s_mode_t)(I2S_MODE_MASTER | I2S_MODE_RX); i2s.sample_rate = sampleRate_; i2s.bits_per_sample = I2S_BITS_PER_SAMPLE_16BIT; i2s.channel_format = I2S_CHANNEL_FMT_ALL_LEFT; i2s.communication_format = I2S_COMM_FORMAT_STAND_I2S; i2s.intr_alloc_flags = ESP_INTR_FLAG_LEVEL1; i2s.dma_buf_count = 8; i2s.dma_buf_len = 64; i2s.use_apll = false; i2s.tx_desc_auto_clear = true; i2s.fixed_mclk = 0; i2s.mclk_multiple = I2S_MCLK_MULTIPLE_256; i2s.bits_per_chan = I2S_BITS_PER_CHAN_16BIT; i2s.chan_mask = (i2s_channel_t)(I2S_TDM_ACTIVE_CH0 | I2S_TDM_ACTIVE_CH1 | I2S_TDM_ACTIVE_CH2 | I2S_TDM_ACTIVE_CH3); i2s.total_chan = 4; if (i2s_driver_install(MIC_I2S_PORT, &i2s, 0, nullptr) != ESP_OK) { Serial.println("Mic I2S install failed"); return false; } i2s_pin_config_t pins = {}; pins.mck_io_num = BOARD_ES7210_MCLK; pins.bck_io_num = BOARD_ES7210_SCK; pins.ws_io_num = BOARD_ES7210_LRCK; pins.data_in_num = BOARD_ES7210_DIN; pins.data_out_num = I2S_PIN_NO_CHANGE; i2s_set_pin(MIC_I2S_PORT, &pins); i2s_zero_dma_buffer(MIC_I2S_PORT); running_ = true; if (xTaskCreatePinnedToCore(taskEntry, "sound-detector", 8192, this, 4, &task_, 0) != pdPASS) { running_ = false; i2s_driver_uninstall(MIC_I2S_PORT); Serial.println("Mic task create failed"); return false; } return true; } void SoundDetector::taskEntry(void *arg) { static_cast(arg)->taskLoop(); } void SoundDetector::suppress(uint32_t ms) { suppressUntil_ = millis() + ms; } void SoundDetector::taskLoop() { static int16_t block[MIC_BLOCK_FRAMES * MIC_CHANNELS]; for (;;) { size_t bytesRead = 0; esp_err_t err = i2s_read(MIC_I2S_PORT, block, sizeof(block), &bytesRead, portMAX_DELAY); if (err != ESP_OK || bytesRead == 0) { vTaskDelay(pdMS_TO_TICKS(10)); continue; } size_t frames = bytesRead / (MIC_CHANNELS * sizeof(int16_t)); if (frames == 0) continue; if ((int32_t)(millis() - suppressUntil_) < 0) { // Still drain I2S so the DMA doesn't overflow while muted. Drop the // envelopes too, otherwise the device's own ping would be the first // thing the detector reports once the mute expires. envL_ = 0.0f; envR_ = 0.0f; publish(0.0f, 0.0f, 0.0f, 0.0f, false); continue; } processBlock(block, frames); } } void SoundDetector::processBlock(const int16_t *frames, size_t frameCount) { int64_t sumL = 0, sumR = 0; int64_t sqL = 0, sqR = 0; for (size_t i = 0; i < frameCount; i++) { int32_t l = frames[i * MIC_CHANNELS + MIC_SLOT_LEFT]; int32_t r = frames[i * MIC_CHANNELS + MIC_SLOT_RIGHT]; sumL += l; sumR += r; sqL += (int64_t)l * l; sqR += (int64_t)r * r; } float meanL = (float)sumL / (float)frameCount; float meanR = (float)sumR / (float)frameCount; float varL = (float)sqL / (float)frameCount - meanL * meanL; float varR = (float)sqR / (float)frameCount - meanR * meanR; if (varL < 0.0f) varL = 0.0f; if (varR < 0.0f) varR = 0.0f; // Normalise to full scale, then smooth with a fast attack / slow release. float rmsL = sqrtf(varL) / 32768.0f; float rmsR = sqrtf(varR) / 32768.0f; envL_ += (rmsL - envL_) * (rmsL > envL_ ? ENV_ATTACK : ENV_RELEASE); envR_ += (rmsR - envR_) * (rmsR > envR_ ? ENV_ATTACK : ENV_RELEASE); // Per-channel noise floor: fall quickly when it gets quieter, creep up very // slowly so sustained noise does not desensitise the detector. floorL_ += (envL_ - floorL_) * (envL_ < floorL_ ? FLOOR_FALL : FLOOR_RISE); floorR_ += (envR_ - floorR_) * (envR_ < floorR_ ? FLOOR_FALL : FLOOR_RISE); if (floorL_ < 1e-5f) floorL_ = 1e-5f; if (floorR_ < 1e-5f) floorR_ = 1e-5f; float sigL = envL_ - floorL_ * FLOOR_MARGIN; float sigR = envR_ - floorR_ * FLOOR_MARGIN; if (sigL < 0.0f) sigL = 0.0f; if (sigR < 0.0f) sigR = 0.0f; // Adaptive gate: a sound must stand clearly above its channel's floor. float gateL = fmaxf(floorL_ * 2.0f, ABS_GATE); float gateR = fmaxf(floorR_ * 2.0f, ABS_GATE); bool present = (sigL > gateL) || (sigR > gateR); uint32_t now = millis(); if (present) lastActiveMs_ = now; bool active = present || (uint32_t)(now - lastActiveMs_) < HOLD_MS; float total = sigL + sigR; float balance = 0.0f; if (total > 1e-6f) { balance = (sigR - sigL) / total; if (fabsf(balance) < BALANCE_DEADBAND) { balance = 0.0f; } else { // Remove the deadband and rescale the remaining range to +/-1. float sign = balance < 0.0f ? -1.0f : 1.0f; balance = (balance - sign * BALANCE_DEADBAND) / (1.0f - BALANCE_DEADBAND); } } float peak = fmaxf(sigL, sigR); float db = 20.0f * log10f(peak + 1e-9f); float loudness = (db - LOUD_MIN_DB) / (LOUD_MAX_DB - LOUD_MIN_DB); if (loudness < 0.0f) loudness = 0.0f; if (loudness > 1.0f) loudness = 1.0f; #if SOUND_DETECTOR_DEBUG static uint32_t lastPrintMs = 0; if (active && (uint32_t)(millis() - lastPrintMs) > 250) { lastPrintMs = millis(); Serial.printf("mic L=%.4f R=%.4f bal=%+.2f loud=%.2f\n", sigL, sigR, balance, loudness); } #endif publish(sigL, sigR, balance, loudness, active); } void SoundDetector::publish(float left, float right, float balance, float loudness, bool active) { portENTER_CRITICAL(&mux_); reading_.left = left; reading_.right = right; reading_.balance = balance; reading_.loudness = loudness; reading_.active = active; portEXIT_CRITICAL(&mux_); } SoundReading SoundDetector::read() { SoundReading r; portENTER_CRITICAL(&mux_); r = reading_; portEXIT_CRITICAL(&mux_); return r; }