/** * @file Touchpad.ino * @author Lewis He (lewishe@outlook.com) * @license MIT * @copyright Copyright (c) 2023 Shenzhen Xin Yuan Electronic Technology Co., Ltd * @date 2023-04-12 * */ #include #define TOUCH_MODULES_GT911 #include "TouchLib.h" #include "utilities.h" TouchLib *touch = NULL; uint8_t touchAddress = GT911_SLAVE_ADDRESS2; void scanDevices(TwoWire *w) { uint8_t err, addr; int nDevices = 0; uint32_t start = 0; for (addr = 1; addr < 127; addr++) { start = millis(); w->beginTransmission(addr); delay(2); err = w->endTransmission(); if (err == 0) { nDevices++; Serial.print("I2C device found at address 0x"); if (addr < 16) { Serial.print("0"); } Serial.print(addr, HEX); Serial.println(" !"); if (addr == GT911_SLAVE_ADDRESS2) { touchAddress = GT911_SLAVE_ADDRESS2; Serial.println("Find GT911 Drv Slave address: 0x14"); } else if (addr == GT911_SLAVE_ADDRESS1) { touchAddress = GT911_SLAVE_ADDRESS1; Serial.println("Find GT911 Drv Slave address: 0x5D"); } } else if (err == 4) { Serial.print("Unknow error at address 0x"); if (addr < 16) { Serial.print("0"); } Serial.println(addr, HEX); } } if (nDevices == 0) Serial.println("No I2C devices found\n"); } void setup() { Serial.begin(115200); pinMode(BOARD_TOUCH_INT, INPUT); //! The board peripheral power control pin needs to be set to HIGH when using the peripheral pinMode(BOARD_POWERON, OUTPUT); digitalWrite(BOARD_POWERON, HIGH); Wire.begin(BOARD_I2C_SDA, BOARD_I2C_SCL); // Two touch screens, the difference between them is the device address, // use ScanDevices to get the existing I2C address scanDevices(&Wire); touch = new TouchLib(Wire, BOARD_I2C_SDA, BOARD_I2C_SCL, touchAddress); touch->init(); } void loop() { // You can judge the level of the touch interrupt to get whether there is a touch if (digitalRead(BOARD_TOUCH_INT)) { bool res = touch->read(); if (res) { TP_Point p = touch->getPoint(0); Serial.printf("X:%d Y:%d\n", p.x, p.y); } } delay(5); }